Pressing the power button on your computer usually isn’t too much trouble, unless your computer is stored away somewhere hard to reach. [Joonas] has been hard at work on a solution that would also impress his friends, building a knock sensor to turn on his PC.
For around $10 in parts he put together an ATTiny45 that emulates a PS/2 device, which takes advantage of his computer’s ability to boot upon receiving PS/2 input. The build uses a Piezo buzzer and a 1M Ohm resistor as a knock sensor exactly as the official Arduino tutorial demonstrates, and one of those PS/2-to-USB adapters that are most likely lurking in the back corner of every drawer in your office.
[Joonas] used AVRweb to disable the 8X clock divider so there’d be enough clock cycles for PS/2 communication, then loaded some test code to make sure the vibrations were being detected correctly. You can check out his Github for the final code here, and stick around after the break for a quick video demo. Then check out a similar hack with [Mathieu's] home automation knock sensor.
https://www.youtube.com/watch?v=FTVppOZquE8
The size of the beam of light the unit can send to the roof of your home is important when choosing best log splitters for home use.
RépondreSupprimerWhat are Control Valves? Control Valves are devices that vary the size of a flow passage. They are controlled by a signal from a controller and allow for direct control of the flow rate and process quantities.
RépondreSupprimer